+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+--- Forum: General questions about RoboDK (//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+——线程:库卡连接(/Thread-KUKA-connection)
KUKA connection-alesles-01-20-2016
I am trying to connect to KUKA KR5sixx R850 robot.
I have disabled Firewall on KRC side.
FTP connection is O.K., however when I try to connect trough suggested port 7000, connection could not be established.
Is there something that should be run on the KRC side?
RE: KUKA connection-RoboDK-01-26-2016
You should follow the steps in the document here attached.
This will allow you to retrieve the robot position as well as move it to a given position in the simulator. You will also be able to run the program online step by step.
You will need a additional files as well as a robot program on the robot side.
寄一封电子邮件d we will provide you with the program files:
info@www.sinclairbody.com
RE: KUKA connection-mecch-12-27-2016
Hi,
I have problem using kukavarproxy in a KRC2 controller. Could you give information how to open the firewall port in 7000 in the XP embedded KRC2 controller? Thanks
mecch
RE: KUKA connection-mecch-12-29-2016
(01-20-2016, 09:29 AM)alesles Wrote:I am trying to connect to KUKA KR5sixx R850 robot.
I have disabled Firewall on KRC side.
FTP connection is O.K., however when I try to connect trough suggested port 7000, connection could not be established.
Is there something that should be run on the KRC side?
Hi, alesles
I don't know whether my suggestion can apply to KR5sixx R850. I experienced the same situation in KRC2. After I registered those OCX file in Windows XP (regsvr32 cswsk32.ocx), I connected to my KRC2 with port 7000.
mecch
RE: KUKA connection-mecch-01-06-2017
Dear Administrator,
I am new to KRC, I have read the Connect-Kuka-robots-with-RoboDK.pdf , but it is not clear to me, where to find the file Me run MainCom.src mentioned in that document. If possible, would you send me a copy of it.
Best wishes
Thanks.
RE: KUKA connection-RoboDK-05-15-2017
The KUKA SRC program files are named the following way for the most up to date versions:
RoboDKSynch34.src
The last 2 digits represent the version of the robot driver.