+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: No. of Path Points in Curve Follow (/Thread-No-of-Path-Points-in-Curve-Follow)
No. of Path Points in Curve Follow-rik_tonnaer-04-25-2019
Hi,
I am using the RoboDK plugin to transfer a curve using the "Load Curve" command. This automatically generates a curve follow project in RoboDK.
In this case, what drives the amount of path points in the path of the robot? How could I decrease the amount of points in the path that is generated?
Thanks!
My post was to quick. I was looking in the wrong location (RoboDK itself instead of Rhino).
For Future Reference:
In the RoboDK plugin for Rhino, under "Settings" (Rhino Command: RoboDK_Settings) there are linear and angular tolerances, under "Polyline Curve Settings"
RE: No. of Path Points in Curve Follow-Jeremy-04-26-2019
Hi rik,
You are totally right.
For the others who could come across this post, note that this solution also applies to all of our CAD plugins.