RoboDK Forum
Tool Orientations Does not Follow the Path——革命制度党ntable Version

+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Tool Orientations Does not Follow the Path (/Thread-Tool-Orientations-Does-not-Follow-the-Path)



Tool Orientations Does not Follow the Path-moonseon-06-14-2023

On my station, I have a small robot arm with a L-shaped tool and a cylindrical part with a C shaped curve.

The parameter of my tool orientation is 30mm in x-axis and 150mm in z-axis and 90 degree in second rotation. The cylinder is laid in a horizontal direction with a curve on the 1/3 side of the part.

When I use follow curve util, the tool orientation is not pointing out the correct direction. In short, neither the TRF's x nor y axis does not follow the orientation of the path as robot moves through the path.

I usedTool Orientation Follows Pathalgorithm with Don't follow orientation on sharp corners option.

I tried to useAllow a tool Z rotation of +/- 0 deg by steps of 20 deg, but somehow it does not allow me to recognize the start position of the path. So Ikept at 180 deg.

Are there any setting I can try out to make my x axis tool orientation to follow the path?


*The reference frame is in the center of the bottom side of the cylinder, z-axis pointing towards top side of the cylinder.