+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: 2 computers, one RDK file - on one programs work, on other not (/Thread-2-computers-one-RDK-file-on-one-programs-work-on-other-not)
2 computers, one RDK file - on one programs work, on other not-zet-jaro-06-10-2023
Hello guys,
I have one question, we have two computers and programs were generated on one and they work there but when I try to open the solution file on other computer, the programs are not working. Any chance to compare the options of the RoboDK? Or did you already had something like that and can point us out?
Thank you very much!
Kind regards,
Tom
RE: 2 computers, one RDK file - on one programs work, on other not-Albert-06-12-2023
You can selectTool-Optionsand thenSet default settingsto revert settings back to defaults on your computer.
RE: 2 computers, one RDK file - on one programs work, on other not-zet-jaro-06-12-2023
Ok, thanks!
If something similar occurs to someone, check Tools->Options->Motion->Tolerance to avoid 180 deg turns!
Kind regards!
Tom