RoboDK Forum
How to configue (imported) objects as "material"——革命制度党ntable Version

+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: How to configue (imported) objects as "material" (/Thread-How-to-configue-imported-objects-as-material)



How to configue (imported) objects as "material"-WolfgangS-04-05-2023

Hi,
I am starting with RoboDK and have read many basic infomation and have seen some training videos.
But I have not found out how to materialize an object, so that the robot is "recognizing" it as an object where it can't penetrate.
Is there an option available, or do I need to concidere objects when setting up the path?
Thanks a lot,
Wolfgang


RE: How to configue (imported) objects as "material"-Sam-04-05-2023

I am not sure if I understand your question. Are you referring to collision detections?
https://www.youtube.com/watch?v=0hFP7Nc_tHg


RE: How to configue (imported) objects as "material"-WolfgangS-04-06-2023

(04-05-2023, 04:17 PM)Sam Wrote:I am not sure if I understand your question. Are you referring to collision detections?
https://www.youtube.com/watch?v=0hFP7Nc_tHg

You are right, this is what I was looking for. I did a trial with collision detection before and saw that collision is highlighted but still I can move robot through objects.
Thanks for the link. Now I have recognized that robot stoppes when collision is detected, but only in program mode.
After whatching the video I know that this make sense.

Thanks a lot for proper answer.