RoboDK Forum
EXPORTING CAM FROM FUSION 360- Printable Version

+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
ab +——论坛:一般问题out RoboDK (//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: EXPORTING CAM FROM FUSION 360 (/Thread-EXPORTING-CAM-FROM-FUSION-360--6506)



EXPORTING CAM FROM FUSION 360-mikerhodes-02-09-2023

Hi Everyone,

I am trying to import a test engraving toolpath (I know it does not have the proper tool installed) and I cannot for the life of me to get it out of RoboDk.

I have the model on the table, but I cannot get the cam program to show up in the center of the part.

Please the attached files.

I have tried all the RoboDk menu options in Fusion 360, but not of the seem to work. I have clicked on faces etc. The only thing that I can get to come in correctly are points.

I have followed the instructions tot he best of my understanding, but I still cannot get it to work.

Ideas?

MR

Please see the attached files.


RE: EXPORTING CAM FROM FUSION 360-Albert-02-09-2023

You should specify the stock origin in Autodesk Fusion 360. You can do so by following these steps:
  1. Double click your setup (Setup 1)
  2. Select the起源dropdown
  3. You can choose the optionModel origin
See attached image.



RE: EXPORTING CAM FROM FUSION 360-mikerhodes-02-10-2023

Thanks Albert!

This worked.