+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: DENSO ONLINE PROGRAMMING NOT WORKING (/Thread-DENSO-ONLINE-PROGRAMMING-NOT-WORKING)
DENSO ONLINE PROGRAMMING NOT WORKING-mvasquez.7-11-24-2022
Hello
I have been trying to connect Robodk with Denso VP-6243G2U for online programming but the same error appears:
"Can not set to Work=WORK0
Can not set to Tool=TOOL0"
causing an Unknow status.
I have the latest version of Robodk and I have followed the instructions provided by robodk to connect with Denso robots. I believe I have edited the driver properly but when I try to connect the log shows this:(sc_error_1.png).
I hope you can help me.
Best regards,
马可s Vasquez
RE: DENSO ONLINE PROGRAMMING NOT WORKING-Sam-02-07-2023
Did you follow the instructions in our documentation? See//www.sinclairbody.com/doc/en/Robots-Denso.html#DriverDenso.
Are Work0 and Tool0 defined in your controller?