+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+--- Forum: General questions about RoboDK (//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: How to connect/run Mitsubishi RV-3SD from PC (/Thread-How-to-connect-run-Mitsubishi-RV-3SD-from-PC)
How to connect/run Mitsubishi RV-3SD from PC-Hiroe-11-21-2022
Hello,
Our customer would like to know if someone tried running Mitsubishi RV-3SD directly from RoboDK.
控制器cr1d - 700有两个港口(USB2.0和RS232), and he uses the controller offline.
He tried the connection, RoboDK - ToolBox２（Mitsubishi simulator)-RV-3SD, but the best way for him is to connect the PC with the robot withoutToolBox２.
Any advice or information will be appreciated.
RE: How to connect/run Mitsubishi RV-3SD from PC-Albert-11-22-2022
We only tested the Mitsubishi driver with an Ethernet connection. I don't think our driver works with an RS232 connection. It could work with a USB connection if it emulates an Ethernet/socket connection.
Does the controller have an Ethernet port?
If you have an Ethernet port and an assigned IP it would be better to use that connection.