+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: What happened to Mastering Program? (/Thread-What-happened-to-Mastering-Program)
What happened to Mastering Program?-Karl-08-11-2022
See link:Robot Calibration (Laser Tracker) - RoboDK Documentation
This is exactly what I need at the moment, a program to send my arm to the proper home position so I can unmaster and remaster it. Did this move somewhere or did we lose it entirely?
I'm using a machinist's caliper otherwise, and it is not enough. A 4-point TCP through the pendant has a mean error of 3mm.
RE: What happened to Mastering Program?-Albert-08-11-2022
你的年代hould selectCalib. param.(calibration parameters), then, selectMasteringand OK to see the mastering option.
RE: What happened to Mastering Program?-Karl-08-11-2022
(08-11-2022, 06:17 AM)Albert Wrote:你的年代hould selectCalib. param.(calibration parameters), then, selectMasteringand OK to see the mastering option.
Works perfectly. Thank you Albert!!