RoboDK Forum
Robot Driver for CPR Mover6- Printable Version

+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ -论坛:通用电气neral questions about RoboDK (//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Robot Driver for CPR Mover6 (/ Thread-Robot-Driver-for-CPR-Mover6)



Robot Driver for CPR Mover6-Rowan Hansard-01-15-2022

Hello,

First of all, I'd like to thank you for this great simulation program!

I am taking part in a student research internship project at my university and we wish to create an educational platform including the CPR Mover6 and RoboDK to enable students to write robot programs and manipulate a robot remotely from their home, in the event of another pandemic.

However, I find I am unable to connect the CPR Mover6 robot to RoboDK as there isn't a robot driver for it in the directory. I read in another thread that a post processor can be used to operate the robot, but I am unable to find that too, as it doesn't appear on the list.

Any help would be greatly appreciated.

Kind regards,
Rowan


RE: Robot Driver for CPR Mover6-Jeremy-01-17-2022

I don't think we have either a post-processor nor a driver for this robot.

Jeremy


RE: Robot Driver for CPR Mover6-Rowan Hansard-01-23-2022

(01-17-2022, 09:08 PM)Jeremy Wrote:I don't think we have either a post-processor nor a driver for this robot.

Jeremy

Very well. I'll see what I can do.

Thank you,
Rowan


RE: Robot Driver for CPR Mover6-Jeremy-01-24-2022

Send me an email, I can send you some material for you to build your own post-processor and potentially your own driver.

Jeremy


RE: Robot Driver for CPR Mover6-Rowan Hansard-02-22-2022

(01-24-2022, 01:49 PM)Jeremy Wrote:Send me an email, I can send you some material for you to build your own post-processor and potentially your own driver.

Jeremy

Hey Jeremy,

I have sent you the requested email. Any material will be greatly appreciated. Thank you.

Rowan


RE: Robot Driver for CPR Mover6-Jeremy-02-24-2022

Just answered you.

Jeremy