+- RoboDK Forum (//www.sinclairbody.com/forum)
+-- Forum: RoboDK (EN) (//www.sinclairbody.com/forum/Forum-RoboDK-EN)
+ - - -论坛:通用RoboDK问题(//www.sinclairbody.com/forum/Forum-General-questions-about-RoboDK)
+--- Thread: Change tool number? (/ 3ad-Change-tool-number)
Change tool number?-galex-11-23-2016
Where change the UTOOL number for Fanuc?
RE: Change tool number?-RoboDK-11-26-2016
You can use the Fanuc post processor called:
Fanuc_R30iA
(right click a program, select "Select Post Processor").
With this post processor, if you use numbered tools and reference frames it should use the appropriate UTOOL and UFRAME respectively. For example, naming your tool "Tool 3" should generate UTOOL 3. Or naming your reference frame "Frame 4" should use UFRAME 4.