12-14-2022, 10:51 AM
hello guys,
i've run into a problem again, this time i got the curves on the object working but the normals of those lines are not following the surface of the object.
i tried to fix it with "tilt curve normals" but that is neither accurate nor fast, the products we want to sand are also to complex and curved to do this by hand. the python scripts included in the RoboDK directory didn't fix the problem either, the arrows keep pointing in the same direction, even when upping the linear, angular and curve accuracy.
i'll inlcude the file these problems occur with, i hope there is a simple solution to fix those normals so the tool can follow the surface of the object.
i've run into a problem again, this time i got the curves on the object working but the normals of those lines are not following the surface of the object.
i tried to fix it with "tilt curve normals" but that is neither accurate nor fast, the products we want to sand are also to complex and curved to do this by hand. the python scripts included in the RoboDK directory didn't fix the problem either, the arrows keep pointing in the same direction, even when upping the linear, angular and curve accuracy.
i'll inlcude the file these problems occur with, i hope there is a simple solution to fix those normals so the tool can follow the surface of the object.