06-30-2022, 07:13 AM
Hey guys,
I do have a question concerning the "avoid arcs" function in RoboDk.
I would like to convert a series of Move_Curve commands in smaller, linear Movements (and a lot of them).
For this I want to use the "avoid curve" function.
But when activated the generated krc4 Code is not what I would expect. There are 12 curve movements in total and after "avoiding curves" 12 linear movements (the same points), no further points were interpolated.
I attached the station for further reference.
Follow these steps to generate arcs as small linear movements:
1.SelectTools➔Options.
2.Select theProgram选项卡。
3.SelectAvoid arcs.
4.Specify theMaximum arc size (mm)which defines the size of the linear movements along the arc.
I interpret point 4 as the said "interpolation" function of the "avoid curves" strategy.
Thanks in advance
Hermann
I do have a question concerning the "avoid arcs" function in RoboDk.
I would like to convert a series of Move_Curve commands in smaller, linear Movements (and a lot of them).
For this I want to use the "avoid curve" function.
But when activated the generated krc4 Code is not what I would expect. There are 12 curve movements in total and after "avoiding curves" 12 linear movements (the same points), no further points were interpolated.
I attached the station for further reference.
Follow these steps to generate arcs as small linear movements:
1.SelectTools➔Options.
2.Select theProgram选项卡。
3.SelectAvoid arcs.
4.Specify theMaximum arc size (mm)which defines the size of the linear movements along the arc.
I interpret point 4 as the said "interpolation" function of the "avoid curves" strategy.
Thanks in advance
Hermann