Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Setrobot.exe not running

#1
Question
Hello, I am attempting the setup the maketp.exe file, but it is asking me to run setrobot.exe first. When I select run as administrator, a command prompt flickers, but nothing else happens. Do I need to create a cell first? I am quite confused.

Thank you,

Jeremiah~ Robotics Developer
#2
Yes, you should first create a Roboguide cell, save it and run this setrobot command. Make sure to create a cell with a robot having the same number of axes.

Make sure to include the correct number of external axes if you have any.

Once you have a Roboguide cell saved you'll then be able to select that cell with setrobot.
#3
(08-04-2022, 06:59 AM)Albert Wrote:Yes, you should first create a Roboguide cell, save it and run this setrobot command. Make sure to create a cell with a robot having the same number of axes.

Make sure to include the correct number of external axes if you have any.

Once you have a Roboguide cell saved you'll then be able to select that cell with setrobot.
Awesome, now I'm not getting a grey pop-up box saying "error executing maketp: path not found"
I'm not sure why this would be. I was able to make it work by loading the ls file directly into the cell in roboguide and then loading it from there, but not directly from robodk.




Users browsing this thread:
1 Guest(s)