|
RoboDK run on robot Question
|
11-02-2022, 06:17 PM
Dear Sir
I can already connect to the TM5-700, but when I run the program, I can only run one point and the connection will be disconnected. How to run the entire program. 
11-02-2022, 06:40 PM
Do you see anything special in the "show log" file?
Or in the robot controller log?
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.
11-03-2022, 03:13 PM
Did you connect to the correct Ethernet port on your controller?
I believe there is only 1 port that allows controlling the robot. Are you using a recent version of RoboDK?
11-03-2022, 03:44 PM
I've been able to successfully wire and drive the arm with the RoboDK, but only move one point at a time. If there is more than one point in the program, only one point is active, and the entire program cannot be executed. As long as a point is moved, the connection will be automatically disconnected. How to fix.Thanks
11-08-2022, 06:00 PM
Can you share the log file of TM Flow?
Jeremy
Find useful information about RoboDK and its features by visiting ourOnline Documentationand by watching tutorials on ourYoutube Channel.
|
| Users browsing this thread: |
| 1 Guest(s) |
