[Tribor83]

Hello,

Is there Kawasaki post-processor what support the Kawasaki welding sepcific AS codes?
如。:镜 = Linear Weld Start;LWC= Linear Weld Continuous;LWE= Linear Weld End


Best Regards,

Tibi

[Albert]

Yes, weld movements are supported with Kawasaki robot controllers.

You should trigger the start and end of a weld path using ArcStart/WeldStart and ArcEnd/WeldEnd respectively.

[Tribor83]

Yes, weld movements are supported with Kawasaki robot controllers.

You should trigger the start and end of a weld path using ArcStart/WeldStart and ArcEnd/WeldEnd respectively.

Thanks Albert,

It's looks good.

Tibi