03-23 -2023, 02:43 PM
Hello,
In the attached RoboDK file, when synchronizing axes and choosing "Priorizing external axis" in order to have only the table turning, the preview for the "curve following" is OK but the created trajectory does not correspond.
On the attached preview, you can see that the tool has always the same orientation relatively to the curve, like I wish. In my opinion that means that the flange will remain in the same position all along the trajectory, and it is OK for me.
However, when you click "Simulate", the position of the flange relatively to the curve during the trajectory changes, and I don't know why.
Does someone is able to explain me :
- why the arm doens not remain static as shown in the preview ?
- how to configure the synchronization parameters to have the arm at the same position where as the table is turning ?
Thanks in advance for your help
In the attached RoboDK file, when synchronizing axes and choosing "Priorizing external axis" in order to have only the table turning, the preview for the "curve following" is OK but the created trajectory does not correspond.
On the attached preview, you can see that the tool has always the same orientation relatively to the curve, like I wish. In my opinion that means that the flange will remain in the same position all along the trajectory, and it is OK for me.
However, when you click "Simulate", the position of the flange relatively to the curve during the trajectory changes, and I don't know why.
Does someone is able to explain me :
- why the arm doens not remain static as shown in the preview ?
- how to configure the synchronization parameters to have the arm at the same position where as the table is turning ?
Thanks in advance for your help