Hello,
I want to drive a stepper motor by sending steps through the I/O outputs. I can do it but my problem is that my extruder is not synchronized with the movement of my robot... My extruder works at first, then my movement is done...
Do you have an idea to synchronize them?
An exemple of my code in attachments.
Thanks
Paul
I want to drive a stepper motor by sending steps through the I/O outputs. I can do it but my problem is that my extruder is not synchronized with the movement of my robot... My extruder works at first, then my movement is done...
Do you have an idea to synchronize them?
An exemple of my code in attachments.
Thanks
Paul