Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connection problems between RoboDK and NX100 motoman controller
#1
Hi,

I'm having some problems connecting RoboDK to NX100 Motoman controller. 我在这里的所有步骤//www.sinclairbody.com/doc/en/Robot-Drivers....oubleshoot,//www.sinclairbody.com/doc/en/Robots-Motoman.htmland made a ping test. The communication between my computer and the controller was successfully done. However, I still couldn't connect and didn't figure out a way to fix it while I succeeded in connecting RoboDK with DX100 and YRC1000 controllers. Can you guys suggest to me some solutions for these problems?

Thanks.
#2
Hi lehoanganhtai,
Did you found the solution for this problem?

We are dealing with the same issue with two Motoman controllers(DX100 and NX100).


Kind regards,
Mihail
#3
Did you place the robot in Remote mode? This is a switch in the teach pendant.

Right after you connect, does it work if you select Get Position in the connection panel?
#4
Hello Albert,
Yes I have tried it with the teach pendant in "Remote Control" mode.
And I also have tried the buttons "Get Position", "Move Joints" and "Stop"... and in the log file I am getting always "connection problems"




Users browsing this thread:
1 Guest(s)