RoboDK Forum> RoboDK (EN)> General questions about RoboDK> NACHI POST PROCEESOR ERROR
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> NACHI POST PROCEESOR ERROR

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

NACHI POST PROCEESOR ERROR
m_zadra Offline
Junior Member
*
Posts: 5
Threads: 2
Joined: Feb 2019
Reputation: 0
#1
02-28-2019, 03:47 PM
I am using the evaluation copy in order to understand if the program can fulfill my requirements. I can easily write a Robot Machining Project and it works fine on the PC but when I generate the robot program I get the errors that you can see in the attachment. Am I doing anything wrong? Is it due to the evaluation copy?

Thank you

Find
Reply


Messages In This Thread
NACHI POST PROCEESOR ERROR - bym_zadra- 02-28-2019, 03:47 PM
RE: NACHI POST PROCEESOR ERROR - byJeremy- 02-28-2019, 05:46 PM
RE: NACHI POST PROCEESOR ERROR - bym_zadra- 03-01-2019, 10:30 AM
RE: NACHI POST PROCEESOR ERROR - byJeremy——04:33 03-01-2019点
RE: NACHI POST PROCEESOR ERROR - bym_zadra- 03-02-2019, 01:03 PM
RE: NACHI POST PROCEESOR ERROR - byAlbert- 03-05-2019, 02:17 PM
RE: NACHI POST PROCEESOR ERROR - bym_zadra- 03-05-2019, 04:08 PM



Users browsing this thread:
1 Guest(s)