Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

CRX-10iA/L "Move joints" does not work.

#9
(07-28-2021, 12:28 AM)Albert Wrote:Dear Keisuke,

The options should bePC InterfaceandUser Socket Messagingas Jeremy mentioned. I see both options listed in the Fanuc official website:
https://www.fanucamerica.com/products/robots/software

More information here:
//www.sinclairbody.com/doc/en/Robots-Fanuc.html#DriverFanuc

Are you located in Japan? Maybe the name is different in Japanese?

Albert

Dear Albert,

Thanks for the reply.

We are in Japan.
I will check with FANUC in Japan.

Best Regards,
Keisuke Sakai


Messages In This Thread
RE: CRX-10iA/L "Move joints" does not work. - byKeisuke.Sakai- 07-28-2021, 01:03 AM



Users browsing this thread:
1 Guest(s)