RoboDK Forum> RoboDK (EN)> General questions about RoboDK> CRX-10iA/L "Move joints" does not work.
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> CRX-10iA/L "Move joints" does not work.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

CRX-10iA/L "Move joints" does not work.
Keisuke.Sakai Offline
Member
**
Posts: 17
Threads: 7
加入:2021年7月
Reputation: 0
#3
07-26-2021, 04:55 AM (This post was last modified: 07-26-2021, 05:01 AM byKeisuke.Sakai.)
(07-23-2021, 06:02 PM)Jeremy Wrote:I would say the same applies to the CRX series as to any other Fanuc series.

You can find the requirement here://www.sinclairbody.com/doc/en/Robots-Fanuc.html#Fanuc

Dear Jeremy,

Thanks for the reply.

I followed the steps in//www.sinclairbody.com/doc/en/Robots-Fanuc.html#Fanucand set it up.
However, it did not work.
The log is in the attached.

Is there something I am missing in the settings?
Do I need option "User Socket Messaging" and "PC Interface" to control the robot using the Robot Driver?


Best regards,
Keisuke Sakai


Attached Files Thumbnail(s)

Find
Reply


Messages In This Thread
RE: CRX-10iA/L "Move joints" does not work. - byKeisuke.Sakai- 07-26-2021, 04:55 AM



Users browsing this thread:
1 Guest(s)