[GreenGuy]

Hi,

Here is the .rdk station.

Test_PostPrecessor_MoveP.rdk(Size: 2.56 MB / Downloads: 280)

I understand that if I set the Rounding value too high it will be reduced to 40% of the distance between 2 points.



Here I set the Rounding value to 0.050, which is too high because the distance between 2 points is 45mm (I think). As a result, the value is reduced to 0.018.





But when I use the latest Post Processor instead of an older one, the Rounding value is always set to 0.000.


GreenGuy