RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Fanuc program with external axis
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Fanuc program with external axis

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Fanuc program with external axis
Appie Offline
Member
**
Posts: 17
Threads: 9
Joined: Apr 2021
Reputation: 0
#1
05-20-2021, 11:42 AM
Hello,

The generated roboDK program for Fanuc uses position register to define the user and the tool frame, that works fine with one group, but not with two groups (with external axis) the robot controller cannot read the values. Is there any configuration to allow the robot to reads that?

Regards,


Attached Files Thumbnail(s)

Find
Reply


Messages In This Thread
Fanuc program with external axis - byAppie- 05-20-2021,上午11:42
RE: Fanuc program with external axis - byJeremy- 05-21-2021, 10:24 AM
RE: Fanuc program with external axis - byAppie- 05-21-2021, 02:14 PM
RE: Fanuc program with external axis - byJeremy- 05-25-2021, 07:48 PM



Users browsing this thread:
1 Guest(s)