Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

3d Printing w/ ABB4600

#2
Hi Jaren,

As far as I know, you don't need anything else.

Btw, PC-Interface is only required if you are using the Driver, which I suspect you won't do for 3D printing as you need fluid motion.
Fluid motion can only be achieved with generated code (programed with RoboDK) uploaded on the controller.

Jeremy
Find useful information about RoboDK and its features by visiting our2022世界杯32强赛程表时间 and by watching tutorials on ourYoutube Channel.




Messages In This Thread
3d Printing w/ ABB4600 - byjarenf- 05-03-2021, 06:33 PM
RE: 3d Printing w/ ABB4600 - byJeremy- 05-04-2021, 08:41点
RE: 3d Printing w/ ABB4600 - byjarenf- 05-04-2021, 09:27 PM



Users browsing this thread:
1 Guest(s)