Hello,
I'm in the process of setting up two extruders for 3d printing, on a pair of ABB 4600's controlled with an IRC5. Are there any ABB software options that I am missing? The only one that I know I'll need for sure is "616 -- PC interface", which is already installed.
提前谢谢!
Jaren
I'm in the process of setting up two extruders for 3d printing, on a pair of ABB 4600's controlled with an IRC5. Are there any ABB software options that I am missing? The only one that I know I'll need for sure is "616 -- PC interface", which is already installed.
提前谢谢!
Jaren