Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Connect RoboDK with Kukarobot/WorkVisual

#3
(04-15-2021, 09:17 PM)colinb83 Wrote:Wov is seperate from rdk, you install the drivers on the robot directly, goto the network settings and find the ip of the robot, 7000 is the port address

Did you follow the instructions?

Also kss version would help, krc4 isn't very specific.

Hello Colin,

thank you for your answer.
这是我的first day with RoboDK and I am pretty new to robots in general. So it is a bit confusing which part is connected to whom and for what reason and/or port.
I work with:
KUKA KR 150 R3300 K prime
KSS 8.3.43



I was not aware of the wiki-like documentation of RoboDK and thus the drivers. So far I plan on monday to use "kukavarproxy.exe" on the HMI.
A quick search revealedthis post. I can't navigate to the drivers page directly, but I will use this for now.


Messages In This Thread
Connect RoboDK with Kukarobot/WorkVisual - byTim- 04-15-2021, 08:36 PM
RE: Connect RoboDK with Kukarobot/WorkVisual - byTim- 04-16-2021, 03:11 PM



Users browsing this thread:
1 Guest(s)