03-10-2021, 01:54 PM
Hi Pavel,
It is not possible to set the acceleration from APT code. However, you can create code output using the command CODE and customize your output in the post. You can also create program calls with the command CALL, you can then change the acceleration in a subprogram.
More information about the supported commands here:
//www.sinclairbody.com/forum/Thread-Program-...59#pid3959
Albert
It is not possible to set the acceleration from APT code. However, you can create code output using the command CODE and customize your output in the post. You can also create program calls with the command CALL, you can then change the acceleration in a subprogram.
More information about the supported commands here:
//www.sinclairbody.com/forum/Thread-Program-...59#pid3959
Albert