RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Welding Path questions
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Welding Path questions

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Welding Path questions
重量 Offline
Junior Member
*
Posts: 2
Threads: 1
Joined: Feb 2021
Reputation: 0
#4
03-01-2021, 10:12 PM
Thank you for the response, that answers my question.

One other question. Is there a macro for "multi pass". Something that would pattern curves or tool paths like this:https://www.wcwelding.com/images/mig-mul...elding.jpg

Thank You
Find
Reply


Messages In This Thread
Welding Path questions - by重量- 02-27-2021, 01:46 PM
RE: Welding Path questions - bycolinb83- 02-27-2021, 02:49 PM
RE: Welding Path questions - byJeremy- 03-01-2021, 06:08PM
RE: Welding Path questions - by重量- 03-01-2021, 10:12 PM
RE: Welding Path questions - byJeremy- 03-02-2021, 01:17 AM
RE: Welding Path questions - bypaulheck- 11-08-2021, 12:14 PM



Users browsing this thread:
1 Guest(s)