02-27-2021, 02:49 PM
How are you creating the paths to start with? if you look at the ABB example 03 they have a welding station that follows a toolpath, and you can see the "toolpath normals" in the RDK station as little lines pointing out from the toolpath.
This sounds like something you need for your project, If you have 5axis programming ability this is not an overly complicated thing to do, it would be a fairly simple pencil type toolpath that any good CAM programmer could do for you for a crate of beer.
Await a response from the RDK guys as they might have another method to achieve what you need, they normally respond quite quickly on a weekday.
Col
This sounds like something you need for your project, If you have 5axis programming ability this is not an overly complicated thing to do, it would be a fairly simple pencil type toolpath that any good CAM programmer could do for you for a crate of beer.
Await a response from the RDK guys as they might have another method to achieve what you need, they normally respond quite quickly on a weekday.
Col