(01-07-2021, 03:38 PM)Jeremy Wrote:Hi Mukesh,
你从我们的文档遵循这些步骤吗?
//www.sinclairbody.com/doc/en/Robots-KUKA.html#KUKA
Jeremy
yes i followed these steps.
Hi Jermy,
i am able to connect my KUKA KR3 R540 but when i create a programme and tried to run it then there is no movement of my KUKA manipulator. the message shows its working . i doble click on the programme the yellow arrow stops on my first joint movement.
Regards
Mukesh