RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problem whit mastercam and robodk
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problem whit mastercam and robodk

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Problem whit mastercam and robodk
Bruno Offline
Junior Member
*
Posts: 4
Threads: 2
Joined: Jan 2021
Reputation: 0
#3
01-05-2021, 10:24 PM
(01-03-2021, 05:51 AM)Jeremy Wrote:Hi Bruno,

Have you look at this part of the documentation://www.sinclairbody.com/doc/en/Plugin-Mastercam.html#Mcam

Jeremy

Hello Jeremy,
Thank you for the help with the previous issue - it's fixed now.
However a new problem appeared - when sending the .NC file to RoboDK, the correct tool id is shown but the tool length is not added to the spindle. In RoboDK the option to create cutters is on.
这be a problem with the post-processor? Is there a way to alter the following code so it considers the tool length?
Find
Reply


Messages In This Thread
Problem whit mastercam and robodk - byBruno- 01-02-2021, 04:42 PM
RE: Problem whit mastercam and robodk - byJeremy- 01-03-2021, 05:51 AM
RE: Problem whit mastercam and robodk - byBruno- 01-05-2021, 10:24 PM
RE: Problem whit mastercam and robodk - byJeremy- 01-07-2021, 03:44 PM
RE: Problem whit mastercam and robodk - byAlbert- 01-11-2021, 06:15 PM
RE: Problem whit mastercam and robodk - byJeremy- 06-03-2021, 08:19 AM
RE: Problem whit mastercam and robodk - byJeremy- 06-07-2021, 03:04 PM
RE: Problem whit mastercam and robodk - byJeremy- 06-07-2021, 08:17 PM



Users browsing this thread:
1 Guest(s)