12-14-2020, 02:55 PM
Hi,
When I try to use the GetDI command on a techmanTM12. The command I am using is shown below.
robot.getDI('1')
When the software gets to this line of code, the robot starts making weird movements that are not in the software, and then the connection between the robot, and roboDK is lost.
When I comment this line of code, the software runs without a single problem.
Does anyone have a suggestion to tackle this problem?
提前谢谢!
When I try to use the GetDI command on a techmanTM12. The command I am using is shown below.
robot.getDI('1')
When the software gets to this line of code, the robot starts making weird movements that are not in the software, and then the connection between the robot, and roboDK is lost.
When I comment this line of code, the software runs without a single problem.
Does anyone have a suggestion to tackle this problem?
提前谢谢!