RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 连接到Fanuc rj3ic
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 连接到Fanuc rj3ic

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

连接到Fanuc rj3ic
Jeremy Offline
Moderator
*****
Posts: 1,832
Threads: 2
Joined: Oct 2018
Reputation: 70
#4
09-25-2020, 06:54 PM
Hi Michel,

Did you follow these steps?
//www.sinclairbody.com/doc/en/Robots-Fanuc.html#DriverFanuc

What version of the controller are you using?
Make sure to use the right version of the driverrdk_s3, there's a version for v6 to v8 and one version for V9 and higher.

Jeremy
Find
Reply


Messages In This Thread
连接到Fanuc rj3ic - bycroesconnect- 09-24-2020, 05:36 AM
RE: Connect to Fanuc rj3ic - byJeremy- 09-24-2020, 06:03 PM
RE: Connect to Fanuc rj3ic - bycroesconnect- 09-25-2020, 01:55 PM
RE: Connect to Fanuc rj3ic - byJeremy- 09-25-2020, 06:54 PM
RE: Connect to Fanuc rj3ic - bycroesconnect- 09-26-2020, 06:07 AM
RE: Connect to Fanuc rj3ic - byJeremy- 09-28-2020,11:57 PM
RE: Connect to Fanuc rj3ic - bycroesconnect- 09-29-2020, 06:08 AM
RE: Connect to Fanuc rj3ic - byJeremy- 09-30-2020, 02:54 AM
RE: Connect to Fanuc rj3ic - bycroesconnect- 10-02-2020, 02:58 PM
RE: Connect to Fanuc rj3ic - byJamie4563- 11-18-2021, 05:56 PM



Users browsing this thread:
1 Guest(s)