09-24-2020, 06:03 PM
Hi Croesconnect,
I hope you are well.
Maybe I'm stating the obvious, but you need to make sure that the driver program (on the Fanuc controller) is actually running before sending the "Get Position" request.
Do you see any error message on the Teach Pendant?
In RoboDK connection window, there's "Show Log".
What does it say?
Jeremy
I hope you are well.
Maybe I'm stating the obvious, but you need to make sure that the driver program (on the Fanuc controller) is actually running before sending the "Get Position" request.
Do you see any error message on the Teach Pendant?
In RoboDK connection window, there's "Show Log".
What does it say?
Jeremy