09-24-2020, 05:36 AM
你好,
I am trying to use roboDK with an Fanuc R-j3ic controller.
I have put the fanuc drivers on the fanuc , when i connect tot he robot with the ip address and port 2000 it say” connected “in green so that is ok.
Only when i click on get position then it disconnect.
Also when i jog the robot with the teachpendant i do not see the robot on the screen moving and also not see the values changing.
I am trying to use roboDK with an Fanuc R-j3ic controller.
I have put the fanuc drivers on the fanuc , when i connect tot he robot with the ip address and port 2000 it say” connected “in green so that is ok.
Only when i click on get position then it disconnect.
Also when i jog the robot with the teachpendant i do not see the robot on the screen moving and also not see the values changing.