08-12-2020, 09:07 PM
Hi Kopler,
Do you use DXF2Gcode to generate your gcode?
If so, the settings you are looking for are in there.
You can decide how much you want to retract (or not retract) in the parameters. That should save you a lot of time.
Then added to a good blending/rounding value (you may need to do some tests to find the best value) you should be able to avoid to many acceleration and deceleration.
Jeremy
Do you use DXF2Gcode to generate your gcode?
If so, the settings you are looking for are in there.
You can decide how much you want to retract (or not retract) in the parameters. That should save you a lot of time.
Then added to a good blending/rounding value (you may need to do some tests to find the best value) you should be able to avoid to many acceleration and deceleration.
Jeremy