RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Techman Flow File Import
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Techman Flow File Import

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Techman Flow File Import
LaugeS Offline
Junior Member
*
Posts: 4
Threads: 1
Joined: Jul 2020
Reputation: 0
#3
07-31-2020, 07:58 AM
Hi Albert,

Yes I'm using Windows 10.
RoboDK is already up to date.
Import is done according to the guide.

I took a look into the *.dat file in the generated project and see that, when specifying the point position "Type" is "Offline" - in a project generated directly on the Robot's TM Flow "Type" is "R"
Also "robot_model" is not defined in a project generated directly on the robot.

请看下面的图片。

Do you think this have an influence on the behavior ?






Best regards,
Lauge
Find
Reply


Messages In This Thread
Techman Flow File Import - byLaugeS- 07-30-2020, 06:44 AM
RE: Techman Flow File Import - byAlbert- 07-30-2020, 05:15 PM
RE: Techman Flow File Import - byLaugeS- 07-31-2020, 07:58 AM
RE: Techman Flow File Import - byAlbert- 08-01-2020, 12:34 AM
RE: Techman Flow File Import - byLaugeS- 08-03-2020, 11:25 AM
RE: Techman Flow File Import - byJeremy- 08-03-2020, 04:01 PM
RE: Techman Flow File Import - byLaugeS- 08-04-2020, 07:08AM



Users browsing this thread:
1 Guest(s)