Plug-in Solidwork

RyZuu97 Offline

Junior Member

Posts: 5
Threads: 3
Joined: May 2020
Reputation: 0

05-19-2020, 11:21 AM

when RoboDK was in Solidwork, auto setup had a problem "Setting up 'Curve follow project' not completed: Can't simulate or generate programs because the robot can't reach the start point"

Attached Files Thumbnail(s)

Find

Messages In This Thread

Plug-in Solidwork - byRyZuu97- 05-19-2020, 11:21 AM

RE: Plug-in Solidwork - byJeremy- 05-20-2020, 03:20 AM

RE: Plug-in Solidwork - byRyZuu97- 05-20-2020, 01:16 PM

View a Printable Version
Subscribe to this thread

Users browsing this thread:

1 Guest(s)