RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 如何补偿for material thickness?
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> 如何补偿for material thickness?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

如何补偿for material thickness?
JeffNickel Offline
Member
**
Posts: 24
Threads: 16
Joined: Apr 2020
Reputation: 2
#3
04-06-2020, 12:44 AM
Awesome, that’s simple! Also, is it possible to show the material in translucent mode to see the cut paths inside the material? This will generate collision warnings if run but for outputting a graphic for setup reasons?
Thanks again,
Jeff
Find
Reply


Messages In This Thread
RE: How to compensate for material thickness? - byJeffNickel- 04-06-2020, 12:44 AM



Users browsing this thread:
1 Guest(s)