04-02-2020, 01:33 PM
Hi,
我发现在届卡塞尔文献展tion that RoboDK has the CAD to Path feature but I didn't find how to use it:
1- I need the tcp to follow an edge of a part
2- I need to keep the TCP at 30 ou 45 degrees on the whole path
3- is it possible to display the targets generated in the tree?
Thank in advance
我发现在届卡塞尔文献展tion that RoboDK has the CAD to Path feature but I didn't find how to use it:
1- I need the tcp to follow an edge of a part
2- I need to keep the TCP at 30 ou 45 degrees on the whole path
3- is it possible to display the targets generated in the tree?
Thank in advance