Greetings,
I need to send a custom command through the on-line robot driver interface, but when I set the program which contains this instruction in "Run on robot" mode and right click on the instruction then "Execute instruction" (after connecting to the driver of course), nothing is sent - as can be seen in the log window. And this is independent on the actual content of the instruction code.
Any built-in instruction works with the same method (I can see them in the log window and they are properly handled by the driver).
我在跑步RoboDK LUbuntu but one of my colleagues has the same problem on Windows. What is happening?
Thank you in advance,
问候
I need to send a custom command through the on-line robot driver interface, but when I set the program which contains this instruction in "Run on robot" mode and right click on the instruction then "Execute instruction" (after connecting to the driver of course), nothing is sent - as can be seen in the log window. And this is independent on the actual content of the instruction code.
Any built-in instruction works with the same method (I can see them in the log window and they are properly handled by the driver).
我在跑步RoboDK LUbuntu but one of my colleagues has the same problem on Windows. What is happening?
Thank you in advance,
问候