RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problems while changing fanuc M710 geometry
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Problems while changing fanuc M710 geometry

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Problems while changing fanuc M710 geometry
Atmoteam Offline
Junior Member
*
Posts: 3
Threads: 1
Joined: Feb 2020
Reputation: 0
#3
02-27-2020, 01:26 PM (This post was last modified: 02-27-2020, 01:28 PM byAtmoteam.)
Albert, thank you. So, as you said, I tried to do, if it doesn't need to follow the tool along the path, then it will work. In other case, this does not work correctly because the tool is fixed to the 5th axis and is driven by the 6th axis.
May be I need to rebuild robot source?
Find
Reply


Messages In This Thread
RE: Problems while changing fanuc M710 geometry - byAtmoteam- 02-27-2020, 01:26 PM



Users browsing this thread:
1 Guest(s)