02-26-2020, 06:52
(This post was last modified: 02-26-2020, 06:52 AM byMitjaGOLOB.)
Hello!
If I understand correctly, it is possible to run the simulation at the same time in the RoboDK environment as URSim only using the commands: moveJ, moveL, moveC. In this case we use 'Run on robot'.
When using the moveP command, we need to select the appropriate postprocessor (in our case we use: Universal Robots MoveP) and then the 'Send program to robot' command. In this case, we also cannot run simulations in RoboDK and URSim simultaneously.
Can anyone confirm that I understand this right?
Thanks and best regards.
Mitja
If I understand correctly, it is possible to run the simulation at the same time in the RoboDK environment as URSim only using the commands: moveJ, moveL, moveC. In this case we use 'Run on robot'.
When using the moveP command, we need to select the appropriate postprocessor (in our case we use: Universal Robots MoveP) and then the 'Send program to robot' command. In this case, we also cannot run simulations in RoboDK and URSim simultaneously.
Can anyone confirm that I understand this right?
Thanks and best regards.
Mitja