RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Program Event or Function Call for 3D Printing Extruder Control
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Program Event or Function Call for 3D Printing Extruder Control

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Program Event or Function Call for 3D Printing Extruder Control
JFCh Offline
Member
**
Posts: 34
Threads: 4
Joined: Jun 2019
Reputation: 3
#8
02-14-2020, 02:37 PM
Hi Albert. I am using an Arduino controler with the Marlin Firmware to drive the extruder. I would like to interpret the RoboDK's Extruder(x.xxx) function to send my own G-code to the Marlin Firmware.
Find
Reply


Messages In This Thread
RE: Program Event or Function Call for 3D Printing Extruder Control - byJFCh- 02-14-2020, 02:37 PM



Users browsing this thread:
1 Guest(s)