01-24-2020, 08:23 AM
(This post was last modified: 01-24-2020, 08:28 AM byantonkulikov.)
Hi Guys.
I am trying to perform my 3d printing project. I converted my 3D model to G-code using Ultimaker Cura slicer. Then, I uploaded it in RoboDK and created a machining project. But I cannot move uploaded NC file into the working zone where the robot is located. I tried all the features, read all your documentation, but still cannot solve it. What am I doing wrong? I attached my working station to make it clear. Please, zoom out enough to see the uploaded model, it is far from the robot. Thank you.
I am trying to perform my 3d printing project. I converted my 3D model to G-code using Ultimaker Cura slicer. Then, I uploaded it in RoboDK and created a machining project. But I cannot move uploaded NC file into the working zone where the robot is located. I tried all the features, read all your documentation, but still cannot solve it. What am I doing wrong? I attached my working station to make it clear. Please, zoom out enough to see the uploaded model, it is far from the robot. Thank you.