01-08-2020, 09:19 PM
(This post was last modified: 01-08-2020, 09:23 PM byamber.saffen.)
It runs but when it gets to the suctionOn() function call it just prints "Program suctionOn() does not exist. Skipping function call."
When I generate the program, it generates fine and even has the function call where it should be. The robot will do all it's joint movements but skips the call.
To be more clear, it moves when I have 'Run on Robot' selected (but skips the function call). When I generate and send the program (Ctr+F6) it doesn't move at all.
When I generate the program, it generates fine and even has the function call where it should be. The robot will do all it's joint movements but skips the call.
To be more clear, it moves when I have 'Run on Robot' selected (but skips the function call). When I generate and send the program (Ctr+F6) it doesn't move at all.