RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Simulation Output to use in SolidWorks Motion
RoboDK Forum> RoboDK (EN)> General questions about RoboDK> Simulation Output to use in SolidWorks Motion

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Simulation Output to use in SolidWorks Motion
allenbancroft Offline
Member
**
Posts: 14
Threads: 6
Joined: Nov 2019
Reputation: 0
#9
12-07-2019, 04:57 PM
Thank you Albert. I am not sure Jeremy addressed this one but it is on me to send you the file. At this point, I am using the "MonitorJoints" macro to output the data. If I find that isn't cutting it, I will send you the file. I just don't want to take up too much of your time on this one.
Thank you
Allen
Find
Reply


Messages In This Thread
RE: Simulation Output to use in SolidWorks Motion - byallenbancroft- 12-07-2019, 04:57 PM



Users browsing this thread:
2 Guest(s)