11-29-2019, 01:13 PM
Hello all
When "Generating the Robot Program (F6), what is the best "Post Processor" output to allow that data to be imported into Solidworks Motion or Matlab?
The output should give at least:
- Time stamp
- Accelerations
- Position of all joints
This data will ultimately be used to calculate joint torques.
提前感谢您的帮助
Allen
When "Generating the Robot Program (F6), what is the best "Post Processor" output to allow that data to be imported into Solidworks Motion or Matlab?
The output should give at least:
- Time stamp
- Accelerations
- Position of all joints
This data will ultimately be used to calculate joint torques.
提前感谢您的帮助
Allen