09-26-2019, 10:58 AM
(This post was last modified: 09-26-2019, 11:03 AM byJakubPiszczek.)
Hello,
I think i might solved this problem.
I tried to connect to robot by using RoboDK on my PC and directly connection with Ethernet cable to Control Box.
The problem was that every time i tried clicking on "Connect" button there was "Waiting" status and nothing happened.
Solution:
1) I pluged Ethernet cable to router and connected my PC to that router by WiFi to that router. Then I set DHCP to assigns an IP address in PolyScope on control panel (touchscreen) and entered the same address in RoboDK on PC.
2) Robot MUST be in operational mode.
After I have done 1) and 2) robot the connection between PC and CB was established. I think that point 1) is not and issue and a real problem was point 2).
My UR robot is UR10e. I disabled all antivirus and windows firewall. I set remote control on touchscreen.
If that helped, you can send me a bottle of good whiskey :)
I think i might solved this problem.
I tried to connect to robot by using RoboDK on my PC and directly connection with Ethernet cable to Control Box.
The problem was that every time i tried clicking on "Connect" button there was "Waiting" status and nothing happened.
Solution:
1) I pluged Ethernet cable to router and connected my PC to that router by WiFi to that router. Then I set DHCP to assigns an IP address in PolyScope on control panel (touchscreen) and entered the same address in RoboDK on PC.
2) Robot MUST be in operational mode.
After I have done 1) and 2) robot the connection between PC and CB was established. I think that point 1) is not and issue and a real problem was point 2).
My UR robot is UR10e. I disabled all antivirus and windows firewall. I set remote control on touchscreen.
If that helped, you can send me a bottle of good whiskey :)